devonwoody
Established Member
The saga of my table slots on my new scheppach table saw has now pleasantly resolved itself .
It appears if the blade is wound fully to its maxium as per manual of 87mm or thereabouts the blade deflects from its lower blade height settings .
The slots are parallel to the blade providing I do not change the blade height when taking measurements from the blade to the slot. I used to raise the blade to get my calliper into position when trying to get a reading at the back end and I can now see that the blade actually deflects when reaching its stop position causing the reading to change.
Mind you I shall have to watch the fence setting and ruler when getting to the top of the blade! Technical support has suggested a remedy for this but needs a panel removing and perhaps some adjustments made to the winding mechanisms. When I am feeling robust and the concrete floor warms up again I shall have to take a peek .
It appears if the blade is wound fully to its maxium as per manual of 87mm or thereabouts the blade deflects from its lower blade height settings .
The slots are parallel to the blade providing I do not change the blade height when taking measurements from the blade to the slot. I used to raise the blade to get my calliper into position when trying to get a reading at the back end and I can now see that the blade actually deflects when reaching its stop position causing the reading to change.
Mind you I shall have to watch the fence setting and ruler when getting to the top of the blade! Technical support has suggested a remedy for this but needs a panel removing and perhaps some adjustments made to the winding mechanisms. When I am feeling robust and the concrete floor warms up again I shall have to take a peek .