Can I ask all the Scheppach table saw owners out there whether they have an issue with the tilt mechanism?
My saw will not stay at whatever angle I set it to, without locking it very tightly. If I loosen the locking lever, even slightly, the saw just falls away. I thought that the saw would only move when you pull out the height adjustment wheel and that when you release it, it would stay where you set it? I was also under the impression(from previous saws) that the locking lever was only as a back-up in case you accidentally nudged the angle?
I know Scheppach can be quirky, but surely this isn't right? It makes setting it up a bit of a faff. It's also very hard to get it to stay at 90 degrees, as it tends to far over slightly when tightening the lock out lever.
Feel free to educate me. Thanks
My saw will not stay at whatever angle I set it to, without locking it very tightly. If I loosen the locking lever, even slightly, the saw just falls away. I thought that the saw would only move when you pull out the height adjustment wheel and that when you release it, it would stay where you set it? I was also under the impression(from previous saws) that the locking lever was only as a back-up in case you accidentally nudged the angle?
I know Scheppach can be quirky, but surely this isn't right? It makes setting it up a bit of a faff. It's also very hard to get it to stay at 90 degrees, as it tends to far over slightly when tightening the lock out lever.
Feel free to educate me. Thanks
