Router bit query.

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
bosshogg":ip7ybigm said:
Try searching for two flute straight milling cutters. At the same time spiral milling cutters will do the same, sometimes better, cutting and have the advantage of better chip clearance...bosshogg :)

Imagination is more important than knowledge...
Albert Einstein (hammer)


Cheers Bosshog!! I shall check them out later!! :D
 
You should never slap people with cod as it's overfished as it is, may I recommend a dolphin friendly tuna or perhaps a conger eel?

I'd also vote for taking out nearly all the waste with a coping saw or drill first, no point doing the job the slow way with the router

Aidan
 
TheTiddles":1f8ir26u said:
You should never slap people with cod as it's overfished as it is, may I recommend a dolphin friendly tuna or perhaps a conger eel?

I'd also vote for taking out nearly all the waste with a coping saw or drill first, no point doing the job the slow way with the router

Aidan

Haha! good advice about the fish!! :lol:

It would take far too long with a coping saw! I have started with a drill already and have to go against your belief and say that the router would be faster!! :lol:
 

Latest posts

Back
Top