Router bit advice please

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

TJC

Established Member
Joined
25 Aug 2020
Messages
94
Reaction score
24
Location
Surrey
Hi all, I'm finding it harder to locate the type of router bit I think I need than I expected.

I need to remove around 8mm of material from the underside of a table to recess some metal hairpin leg brackets. I've made up a template of the cut out for routing, but now not sure which bit I need.

I have a 1/4" shaft trim router I'm intending to use for this, so not a proper plunge router, but should be sufficient for such a shallow cut in softwood?

I'm looking for a straight spiral cutter with a bearing at the top of the blade - between blade and machine, but struggling to find what I think I need. Should I just run the smooth part of the bit against the template? Any advice appreciated!
 
Do you have a guide bush for your
router? That’s the better tool for it with a plain straight cutter
A
 
No, I only have a trim router currently, and no collar. As such I made my template 1:1 rather than oversized, but did that before bit shopping. Will have to rethink if I can't get a bit...
 
Amazing, thank you. That's no issue, I can lose the pilot hole under where the metalwork will go. I was envisioning something bigger, but that's much better.
 
For what it's worth, I needed a cove bit for my workshop cladding and it was going to be £15 or something for a branded one. For £60 I got the trend set with 30 odd bits including the one you're after for this I think.

I only had a couple of bits so it made sense to me. Many might never get used and some will wear out. But they can all produce a result to give you options. If you use one a lot then buy the more expensive ones.

Edit :scrub that. On looking at it on amazon it doesn't have the one you want in it.
 
Just having a look now, all the sets seem to only have bearings at the wrong end for what I need. I got a set of generic Chinese bits with the router and have the same issue, all coves and round overs and trimmers.

It's ordered now anyway, I got the 12mm deep cutter so it's a little more flexible, but this is a specific job I expect to do a fair amount of, so am haply with it...
 
This sort of thing will come up over and over again during your woodworking, it may be an idea to get a bush set, I managed to attach the Triton base for the bush's to a 1/4" trim router with a little bit of work, I am sure you could do the same.
 
If you're trim router has a round base make up a new template so the whole router fits in.

Pete
 

Latest posts

Back
Top