When the blade is correctly positioned on the top wheel, it's practically falling off the bottom wheel.
I disengaged all guides and it improved.
All seemed fine running by hand, but once doors closed and motor started, it ran out of position on the top wheel altering the position of the blade in relation to the guides. Repeated a few times, same thing when the motor was used to drive the wheels.
Then I tried adjusting again with the motor running, but the tiniest movement on the control led it to wander way beyond what it does turning the wheel by hand.
Seemed odd, and for some reason I pressed down/ pulled up (not with a lot of strength) on the right side of the table. This happens (assuming I can get the vid to embed - I still struggle with the codes):
[youtube]RzVjaZjgnBE[/youtube]
(https://www.youtube.com/watch?v=RzVjaZj ... e=youtu.be)
What on earth is going on?!
I disengaged all guides and it improved.
All seemed fine running by hand, but once doors closed and motor started, it ran out of position on the top wheel altering the position of the blade in relation to the guides. Repeated a few times, same thing when the motor was used to drive the wheels.
Then I tried adjusting again with the motor running, but the tiniest movement on the control led it to wander way beyond what it does turning the wheel by hand.
Seemed odd, and for some reason I pressed down/ pulled up (not with a lot of strength) on the right side of the table. This happens (assuming I can get the vid to embed - I still struggle with the codes):
[youtube]RzVjaZjgnBE[/youtube]
(https://www.youtube.com/watch?v=RzVjaZj ... e=youtu.be)
What on earth is going on?!