Adirondak Chair

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I think this design was made for barbecues, those arms look just right for a plate on one side and a glass on the other :wink:
 
Ok, last pic, I promise :D

All finished, two coats of Danish Oil, and then two coats of Sikkens Cetol HLS pine.

Very pleased with the Sikkens, a cowson to put on ( very thin, runs about a bit) but looks and feels the part :)

adc.jpg


Edit: Thas better :wink:

Deliberate Mistake ( hoping to remedy later)



The first pilot hole drilled with 5/8" countersink on front panel, my plug cutter is 1/2" :roll:
 
Bill,

C'est magnifique! And I see it's all lined up to get a deeper suntan over the summer too. 8) :lol:

Incidentally, that's not a mistake. That's a tool-buying opportunity. :wink:

Cheers, Alf

Looking at the glass half full in sunny Cornwall. Give me a moment though and I can soon remedy that... :wink:
 

Latest posts

Back
Top