You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support UKworkshop.co.uk:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
M
Hello SteveB and welcome.
Surface plane one side of your board, if it is cupped or bowed plane that face first.
Start the cut with...
-
M
I will post finished pictures once done. No pressure.
-
M
I got sorted thanks all, the splayed legs are perfect.
The compound angle on the top and bottom of the legs was obviously important...
-
M
So taking the advice of people above I started to draw a template onto a blank piece. Doing so, I can see how the approach I was taking...
-
M
You could make a template of the taper on some thinner sheet material and trace it out onto the 2 adjacent sides then setup your taper...
-
M
Interesting idea. I can see how it could help. I only have the right looking taper on one side of the leg. If I can get both outside...
-
M
Correct yes. I have 350mm on parraller sides but only about 250mm on the other two. I'm not getting the correct taper.
-
M
Yes you're right. Is it just a matter of figuring out the correct sides of the legs to taper? I've tapered two adjacent sides and left...
-
M
Hi All
I'm trying to make the stool in the pictures 1 and 2. It's my first time making stools. I probably should have started with a...
-
M
Thanks all for your replies.
I now have loads of good options.
I suppose I had better post a few pictures when I finish the trial...
-
M
Excellent. Exactly what I need. Thank you so much.
-
M
Great detail thank you.
I'm planning making 5 stools and have today made a trial stool (the components at least) out of pine to check...
-
M
Yeah I have the free post now once my my order went over about 50 dollars. This brings the whole shipping cost way down. Thank you.
-
M
I saw this done on one website but discounted it as the z-clips kinda jumped out as a long term solution. Maybe it's something worth...
-
M
This is a good idea. I signed up to AddressPal just now. The shipping from Rockler to the AddressPal address in the US is 8 dollars for...
-
Loading…
-
Loading…