jhwbigley
Established Member
..chip extraction hoods for planer thicknessers..
is it just a few bits of mdf, carpenters glue and a few brads???
Thanks
JHB
is it just a few bits of mdf, carpenters glue and a few brads???
Thanks
JHB
Yes.jhwbigley":1t612uif said:..chip extraction hoods for planer thicknessers..
is it just a few bits of mdf, carpenters glue and a few brads???
dickm":1gpz6sjr said:Yes.jhwbigley":1gpz6sjr said:..chip extraction hoods for planer thicknessers..
is it just a few bits of mdf, carpenters glue and a few brads???
Doctor":2yexkfdw said:dickm":2yexkfdw said:Yes.jhwbigley":2yexkfdw said:..chip extraction hoods for planer thicknessers..
is it just a few bits of mdf, carpenters glue and a few brads???
No
big soft moose":1429f2g8 said:I only have a thicknesser but this is my chip extraction technology
jhwbigley":ofhux7p9 said:big soft moose":ofhux7p9 said:I only have a thicknesser but this is my chip extraction technology
Me too,
But getting a little tired of it now :roll:
JHB
Benchwayze":3crsewkz said:jhwbigley":3crsewkz said:big soft moose":3crsewkz said:I only have a thicknesser but this is my chip extraction technology
Me too,
But getting a little tired of it now :roll:
JHB
All this looks so familiar!
I am tired of it too, but I just don't have the room for an extraction system. So I hang a mask and safety specs on a nail!
John
9fingers":12g2tw3d said:You might want to consider making it from aluminium alloy sheet. A lot easier to work, no rust and no need to paint. Pop rivets are nice and easy to use either way.
Sheet metal is mainly metric these days 1.5 to 2mm should be fine 1.5 is easier to bend but if you design out of flat sheet and make the corners from alloy angle it will possibly turn out prettier.
if you plan to weld it, then i'd advise sticking with steel. Aluminium needs lots more skill to weld without blowing holes in it.
Good luck
Bob
Enter your email address to join: