Routing composite shapes

[DaveL]

Blimey. And to think you could probably do the same thing with a couple of planes too...

Best clean the Lewin thats still it's box :roll:

 

[Aragorn]

Aragorn - looking at the first table saw cut I am wondering whether I need to get a thinner saw blade (if such a beast exists) since I think that the blade that came with the table saw is probably too wide for this purpose.

Roger - you should be OK though. The drawings are to scale, and I've used an 1/8th" saw kerf which is normal. Just be careful in setting the blade tilt and height and make test cuts on a longish piece of scrap (e.g. 50-60cm), as this shows up if there are any variations along the length of the timber.

Blimey. And to think you could probably do the same thing with a couple of planes too...

LOL! Not on about planes again ALF! I thought we were passed that. It's chisels now. CHISELS!