V-groove routing

[LBCarpentry]

The point is, that if you're trying to recreate VT&G boarding then having the "flat" will actually give it a more genuine appearance regardless. The thought of cutting grooves with a circular saw / table saw Vs using a router and bit are day and night to me. It would take an eternity to skills it and the results would be sub par without a doubt. In fact, just talking about this makes me feel like I've tried it once and sworn never again. Perhaps I've blocked it out....

Louis

 

[Spectric]

I used this 1/2 inch router bit in my router table to produce 6 inch Sappelle wood paneling with a bead and V profile for the bottom half of our bathroom,

https://www.wealdentool.com/acatalog/Online_Catalogue_Butt_Bead_971.html
I thought this was much easier than trying to make a sheet look like a panel.