sed9888
Established Member
Hi, I have been asked to produce wooden discs in varying sizes and thicknesses, I have a good jig but finding a good bit to cut these clean is difficult ant recommendations or advice would be great 
Router bit advice
- Thread starter sed9888
- Start date
Help Support UKworkshop.co.uk:
sometimewoodworker
Established Member
A compression bit (combined up and down cut) will give the cleanest finish on both sides, but they are rather spendy.Hi, I have been asked to produce wooden discs in varying sizes and thicknesses, I have a good jig but finding a good bit to cut these clean is difficult ant recommendations or advice would be great
https://www.whitesiderouterbits.com/collections/compression-spirals
