Hello,
I have a Scheppach Basato 4 bandsaw and its always run a little shakily. Having levelled it out and put some weight in the bottom it runs with only occasional vibration. I went to change the blade the other day to cut some tenons, while setting up the stop I noticed that the blade was leaning forward by a few degrees!! Turns out the wheels are not aligned. I have managed to get the top wheel off by removing the circlip. Alas, the top wheel can only be adjusted forwards. I removed the circlip on the bottom wheel and tried to remove that to see if I could adjust that. It's having none of it!
Any advice on either, how to remove the bottom wheel or, another solution I haven't thought of would be most appreciated.
Cheers,
Tom
I have a Scheppach Basato 4 bandsaw and its always run a little shakily. Having levelled it out and put some weight in the bottom it runs with only occasional vibration. I went to change the blade the other day to cut some tenons, while setting up the stop I noticed that the blade was leaning forward by a few degrees!! Turns out the wheels are not aligned. I have managed to get the top wheel off by removing the circlip. Alas, the top wheel can only be adjusted forwards. I removed the circlip on the bottom wheel and tried to remove that to see if I could adjust that. It's having none of it!
Any advice on either, how to remove the bottom wheel or, another solution I haven't thought of would be most appreciated.
Cheers,
Tom