Hi folks
I don't think the feed roller on my planer is level with the thicknessing table. Feed is a bit erratic and I can see the marks made by the splined roller on the side near the fence/motor.
Anybody know if it is possible to adjust the level of the feed roller? Thicknessing is fine so cutter head and lower table must be ok.
Thanks
I don't think the feed roller on my planer is level with the thicknessing table. Feed is a bit erratic and I can see the marks made by the splined roller on the side near the fence/motor.
Anybody know if it is possible to adjust the level of the feed roller? Thicknessing is fine so cutter head and lower table must be ok.
Thanks
