Cinimod
Established Member
Afternoon all,
I've just ordered some new bands for my Record bs250 as last one snapped a few days ago. Now I've ordered a Tuffsaws 1/4" and 3/8" for general/small stuff , but also got a 1/2" fast cut to rough cut out 2" thick stock blanks.
Last time I set the saw was with a 3/8 band with the gullets on the crown of the wheel which cuts really well, but is it acceptable or safe to run with the 1/2" band as this would put the back of the band 1/4" out over the back of the wheel.
I know the blurb says you can run a 1/2" band , but am not sure if this is with the gullets on the front of the wheel or on the center :?: :?: :?:
Any advice would be appreciated.....................dom
I've just ordered some new bands for my Record bs250 as last one snapped a few days ago. Now I've ordered a Tuffsaws 1/4" and 3/8" for general/small stuff , but also got a 1/2" fast cut to rough cut out 2" thick stock blanks.
Last time I set the saw was with a 3/8 band with the gullets on the crown of the wheel which cuts really well, but is it acceptable or safe to run with the 1/2" band as this would put the back of the band 1/4" out over the back of the wheel.
I know the blurb says you can run a 1/2" band , but am not sure if this is with the gullets on the front of the wheel or on the center :?: :?: :?:
Any advice would be appreciated.....................dom