I have been occasionally dropping in on a site for routering information, but I have never seen the site mentioned on this forum. So just in case others don't know of it, it is www.patwarner.com .
It is an american site run by, I believe, a one man business, but he seems to know routers and routering inside out, especially the jigs and ancillary equipment side and the tips that make jobs easier or more accurate.
One tip item gleaned from delving into the site was to set -up the router in a table for the maximum depth of cut required, then add 1/4" layers of mdf on top of the table (with a cut-out in each for the cutter) and run the work on that. Repeat the passes after removing the mdf layers one by one. So simple I don't know why I haven't thought of it or seen it mentioned elsewhere. It saves all that rummaging under the table adjusting the cutter height. It also ensure the true verticality is not compromised with each adjustment.
Anyway, if you all know of the site, I'm sorry I have wasted your time; (but then why didn't you mention it for me?)
It is an american site run by, I believe, a one man business, but he seems to know routers and routering inside out, especially the jigs and ancillary equipment side and the tips that make jobs easier or more accurate.
One tip item gleaned from delving into the site was to set -up the router in a table for the maximum depth of cut required, then add 1/4" layers of mdf on top of the table (with a cut-out in each for the cutter) and run the work on that. Repeat the passes after removing the mdf layers one by one. So simple I don't know why I haven't thought of it or seen it mentioned elsewhere. It saves all that rummaging under the table adjusting the cutter height. It also ensure the true verticality is not compromised with each adjustment.
Anyway, if you all know of the site, I'm sorry I have wasted your time; (but then why didn't you mention it for me?)