Hi all
Back from my hols in Greece and straight into the workshop! I need to make some cupboard doors and have been given a cope and stick cutting set on half inch shanks. They are 45mm in diameter. My router is not variable speed - it's a Makita 3612BR and runs at 23000 rpm. Is it ok to use the cutters in this ( in a table!) or do they need to be run at a slower speed........in which case any recommendations for a sub-£100 variable speed half inch router that's easy to use in a table?
Cheers!
Stewart
Back from my hols in Greece and straight into the workshop! I need to make some cupboard doors and have been given a cope and stick cutting set on half inch shanks. They are 45mm in diameter. My router is not variable speed - it's a Makita 3612BR and runs at 23000 rpm. Is it ok to use the cutters in this ( in a table!) or do they need to be run at a slower speed........in which case any recommendations for a sub-£100 variable speed half inch router that's easy to use in a table?
Cheers!
Stewart