I have a Perform CCL lathe I use to turn cork handles for fishing rods.
Looking to remove the taper in the headstock which is in pretty tight I see the centre hole does not go right through which would allow me to push/knock out with a round bar.
The question therefore is how do I get the taper off?
Appreciate any help with this one guys.
Cheers,
TC
Looking to remove the taper in the headstock which is in pretty tight I see the centre hole does not go right through which would allow me to push/knock out with a round bar.
The question therefore is how do I get the taper off?
Appreciate any help with this one guys.
Cheers,
TC