Mcluma
Established Member
This weekend I became the proud owner of a router table

photo by mcluma, on Flickr

photo by mcluma, on Flickr

photo by mcluma, on Flickr
And whilst using it this weekend on some long boards (making my own skirting and architrave mouldings) I wondered if a powerfeed would make the cut any better, it would make it easier that for sure.
So has anybody done it.. - I mean put a power feeder on their router table - i've seen plenty on Spindle moulders

photo by mcluma, on Flickr

photo by mcluma, on Flickr

photo by mcluma, on Flickr
And whilst using it this weekend on some long boards (making my own skirting and architrave mouldings) I wondered if a powerfeed would make the cut any better, it would make it easier that for sure.
So has anybody done it.. - I mean put a power feeder on their router table - i've seen plenty on Spindle moulders