bobham
Established Member
Hi:
My DVR acquired a little brother this week so I decided to put it through its paces on this little project. The camera is just on a tripod so the angle is not the best, but I think it gets the idea across. The new lathe is a General International 25-114 Maxi Lathe VF: http://www.general.ca/site_general/g_pr ... 5-114.html
The video is quite short because I didn't notice that I hadn't started the camera recording until I was a few steps into it.
http://www.youtube.com/watch?v=rfrldsntWbA
Take care
Bob
My DVR acquired a little brother this week so I decided to put it through its paces on this little project. The camera is just on a tripod so the angle is not the best, but I think it gets the idea across. The new lathe is a General International 25-114 Maxi Lathe VF: http://www.general.ca/site_general/g_pr ... 5-114.html
The video is quite short because I didn't notice that I hadn't started the camera recording until I was a few steps into it.
http://www.youtube.com/watch?v=rfrldsntWbA
Take care
Bob