Myford Lathe Advice

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

gregmcateer

Established Member
Joined
16 Jun 2011
Messages
3,281
Reaction score
477
Location
Stourbridge, W Midlands
Evening Folks,
A friend who's Dad has passed away and would like to move his old lathe has asked me to see if any of you good people know;
The model of this lathe
The dismantling and transportability - i.e. Is it relatively straightforward or specialist?
Ians Lathe.JPG


Many thanks in advance,

Greg
 

Attachments

  • Ians Lathe.JPG
    Ians Lathe.JPG
    109.3 KB
It's an ML7 but a high end version with gearbox and clutch.

You will need 2 stout men to move it, but otherwise it's not too bad. They are very badly balanced towards the headstock end so take care there. I recommend removing the tailstock, chuck, cross slide and motor as a minimum.

Nice looking lathe though and extra desirable with the gearbox on it.
 
Blockplane":1vmznnoe said:
Myford 7 series, looks to be a Super 7. Fairly straightforward to move, given sufficient manpower .

Certainly not a Super 7. It's an ML7 (I have both) with Gear-box.

Taken off the stand it can easily be moved by two men in reasonable health. I'm 76, 10st 3 and two days ago I moved my Super 7 from one side of my workshop to the other (about 2½ metres) on my own. ---- No I didn't 'pick it up' -- I 'walked' it :D
 
I had to carry my 7 in to the garage on my own as my lads were away at work :cry:

XOila1K.jpg


It was the same when I traded a woodlathe for this Granville Snior, Removed bits but still almost broke me back!!

No1ISsW.jpg


And again when I 'won' this Startrite bandsaw off the bay, Two big lads put it in to my car but I was on me todd again so I got a spanner and stripped the saw from the stand, Almost all the weight is in the saw though!

OzWQAnr.jpg



John :p
 
Back
Top