My original pot porri lid for the competition

[Dalboy]

For my original pot porri lid for the competition I seemed to have run out of time it involved turning a lid to fit in the pot and the rest hand carved and pierced using a scroll saw. It was quicker to produce the one that can be seen in the competition thread. Well below is how far I managed to get as I had forgotten to allow for time to get ready for a steam rally I attend.
I will finish it and make a new pot to fit it to.

 

[KimG]

Nice idea Dalboy, I would definitely be interested in seeing the finished lid and pot.

 

[Grahamshed]

Nice idea Dalboy, I would definitely be interested in seeing the finished lid and pot.

Me to, though I liked the one you used too.

 

[Dalboy]

This could end up interesting as I would normally turn the pot first, this time I am making the lid and then the pot to finish mind you it should be no different if I had brought one. I have tried to make it about the same size as commercial available ones. Should be able to get back on to the lid tomorrow as I have had a day of rest after a very hectic weekend.

 

[Dalboy]

Well this is now no go project managed to break the lid today

 

[Woodmonkey]

Shame, looks like it might be glueable?