If you're near Nottingham or J24-J27 M1 can you please help?

[Newbie_Neil]

Hi all,

I have a garden swing with a metal frame and it's in good condition, apart from the fact that the front 'legs', that fit into rubber 'feet', have rusted.

If I cut out the rust could someone please make some small pieces for me to go inside the existing 'legs'? It's probably about four or five inches of metal tube that are required, for each side.

I'll happily pay for this.

Thanks for reading,

Neil

 

[flh801978]

I have some stocks of steel in sheffield
I need an accurate inside diameter to match you up

Ian

 

[novocaine]

Can't you just chop 5" of the back legs and shorten the ropes a touch?

 

[Newbie_Neil]

Can't you just chop 5" of the back legs and shorten the ropes a touch?

No, unfortunately it doesn't have the same 'legs' at the back.

 

[Newbie_Neil]

Hi Ian,

I have some stocks of steel in sheffield. I need an accurate inside diameter to match you up. Ian

I've sent you a pm.

Thanks,

Neil

 

[lurker]

What is the ID and od

 

[Newbie_Neil]

Hi Lurker,

What is the ID and od

Yes, I'll get it measured.

Thanks,

Neil

 

[Newbie_Neil]

Hi Lurker,

Thank you, but Ian has kindly offered to do this for me.

All the best,
Neil

 

[flh801978]

Just done out of 50mm galvanised scaffold pipe turned to fit Neil’s id

 

[Newbie_Neil]

Hi Ian,
They look superb. Thank you so much.
Neil

 

[DTR]

Just done out of 50mm galvanised scaffold pipe turned to fit Neil’s id
View attachment 3222

Nice finish!