Hi all - Thanks for answering my questions about sourcing wood, much appreciated!
Now for the daft questions -
1. Where is the best position on the clamps that hold the blades to put the blades? ie. near the front or back.
2. Is this positioning critical? for instance, if I clamped the bottom of the blade near the back of the clamp and the top near the front, the blade wouldnt be plumb, can this cause problems?
3. Sometimes the blade comes loose from one of the clamps, usually the bottom, even though I tightened them as much as I could. Is there a reason for this?
Any help would be much appreciated! thanks!
PS - as soon as I get a few more bits and bobs done, I'll post them here to give you all a good laugh.
Now for the daft questions -
1. Where is the best position on the clamps that hold the blades to put the blades? ie. near the front or back.
2. Is this positioning critical? for instance, if I clamped the bottom of the blade near the back of the clamp and the top near the front, the blade wouldnt be plumb, can this cause problems?
3. Sometimes the blade comes loose from one of the clamps, usually the bottom, even though I tightened them as much as I could. Is there a reason for this?
Any help would be much appreciated! thanks!
PS - as soon as I get a few more bits and bobs done, I'll post them here to give you all a good laugh.