Fitted oak door, bump in floor

[Joe Shmoe]

I've fitted an oakwood veneer door in place of an existing sliding door. When the door is closed, it's bottom edge is level with the floor (12mm gap to allow for coming carpet)

But, there is an unevenly bump in the concrete floor, notable when the door is open.

What are my options?

 

[CHJ]

Fit Rising Butt Hinges.

 

[Bm101]

http://www.screwfix.com/p/rising-butt-h ... pack/73685 Not these ones in particular, grabbed off tinternet and given as example but to give an idea. As the door opens it lifts up.

Edit: Cross post

 

[Jacob]

Either level the floor or trim the door.

 

[banjerbill]

Hi Joe, This thread caught my eye as I have just bought some of these doors. What are they like to fit?
+1 for rising butt hinges, they have helped me deal with uneven floors in the past.

Bill

 

[skipdiver]

If you use rising butts, don't forget to get the correct hand and also you need to angle the top corner of the door on the hinge side, so it doesn't catch the frame as it starts to rise.