glwoodturning
Member
Many years ago, wanting to make a curved door I calculate that if I used coopered [panels and was 1/4 of a degree out My door radius would be out by over an inch. I developed this method using a router table and i think, three cutters. It is still in use and the PVA glue is doing its job. The idea h
as ben published a few times but thought that it may be of use to someone. I can provide more details if required
![door 2.jpg door 2.jpg](https://cdn.imagearchive.com/ukworkshop/data/attach/155/155919-door-2.jpg)
![door 1.jpg door 1.jpg](https://cdn.imagearchive.com/ukworkshop/data/attach/155/155918-door-1.jpg)