Mdotflorida
Established Member
I have an empty (apart from my new machines) double garage to set up a new workshop in. The garage is basically single block construct with an open raftered roofspace. There are 2 glass fibre doors with a large (5-10mm) gap around the sides and bottom an no insulation or heating. The floor is concrete.
My new machines are cast iron and I am keen for them not to become expensive rust over the winter due to condensation problems.
Has anybody had experience of doing this. I would like to keep the roof space as open as possible as it provides useful storage but install some form of insulation up under the rafters. Also I want to block up (internal stud wall not permanently) 1 of the garage doors.
Any advice would be much appreciated.
My new machines are cast iron and I am keen for them not to become expensive rust over the winter due to condensation problems.
Has anybody had experience of doing this. I would like to keep the roof space as open as possible as it provides useful storage but install some form of insulation up under the rafters. Also I want to block up (internal stud wall not permanently) 1 of the garage doors.
Any advice would be much appreciated.