Blade help required

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

drewdt3

Established Member
Joined
27 Mar 2016
Messages
33
Reaction score
0
Location
Mow Cop
Afternoon all

Can anyone help? I'm after a flat toothed blade with a 3mm kerf for an 8" table saw. I've made a box joint jig but the blade I have is an ATB and it shows on the cuts.

Cheers
Drew
 
FYI, I got my blade through and have just tried it out. I got the 6mm blade. It fits perfectly in my saw, with a little bit of clearance.

979872124ebc51ddb2e01326096ac43e.jpg


5a0a30ecabc8003d2ee171968483afdf.jpg


After a few test cuts, I'm very pleased. It's much more prone to chip out than a dado would be, but that's to be expected with such a large cutting tooth. But if you take it slow, or use a zero clearance / sacrificial backing board, it's fine. The groove it cuts is perfectly flat, and a little over the 6mm tooth width.

Very happy thanks again for the link :)
 
Back
Top