Bath Side

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

SteveF

Established Member
Joined
16 Sep 2013
Messages
2,230
Reaction score
1
Location
Maidstone
bath panel has cracked and needs replacing
think it was a wickes but not sure
it is curved (shower end)
are these standard or do I have to "fabricate" something?

Steve
 
If it's a p shaped bath you're better off making something.

You may get a replacement, it might even fit, you'll deffinately require a relaxing bath to get over the cost.
 
Hi Steve

I had a similar problem with a client some time ago; she couldn't get a replacement for her bath as the company had ceased trading.

I made a wood panel: If you chose to do this it's very easy.

First you need to make a template of the exact curve at the edge of the bath (assuming its not just a straight edge!).
From the template (if reqd.) make a couple of frames to match, one for top edge one bor basze and join these together at each end and in the centre somewhere.
Cut a number of vertical panels, the width will need to vary depending upon the radius of the curve.

if you look at my gallery (from hyperlink below) you will see a phot of the finished result.

Hope this is of some use

B Regards David
 

Latest posts

Back
Top