Excellent piece of work =D> Will need to have a look the next time I am in the science centre. I like the fact that each bit has a different jigsaw piece. =D> The display that you have in Strathclyde Uni are they also on view to the public?
Hi Guys. I haven't been on for a while due to ill health. Hopefully I am on the right track to getting better. I also have had loads of problems with my laptop. So I am looking forward to asking for and giving advice. :D
Cheers
Gill Don't feel down hearted. It really is hit and miss. I don't do craft fairs anymore, but when I did I paid anything between £10 and £90 for a table. The 90 pounds fair was a total disaster, didn't make a penny and was moved by Health and Safety into an indoor tent that was playing extremely...
Yeh Bill's tool store is a great store in the barras. You are right about them being limited to quality tools.
I have always bought similar items from Rutlands or axminster because of the same reason as yourself. I know that crockets in Glasgow sell Record Irwin and Stanley Planes. Not to sure...
Thanks for the info guys.
I am going to try the idea that Carlb 40 mentioned. Will try it on scrap bits of wood until I get the hang of it. Hopefully. lol
Will keep you posted on progress.
Cheers.
Thanks for the quick reply Carlb40.
I thought about the Hinges that you show. I have never installed these before although I do have forstner bits. As you know you only get one shot with them. So bit concerned about accuracy when installing them.
Hi there,
i have been asked to install a basic cabinet around a fuse box for a friend. The fuse box is on the wall above an internal door right underneath the stairs :x The right hand side of the cabinet would need to be cut at an angle to accomodate the slope from the stairs.
Apologises but...
I use the Sundstrom half mask respirator. Comes with disposable filters. Very good fit and if sealed in an airtight container filters will last.
Here is a link
http://www.arco.co.uk/products/168600/1 ... Respirator
Excellent buy.
That is a lovely piece of work. =D>
How did you manage to get the flags to be so accurate??.
I'm also glad that you managed to get the Scotland flag in lol
Cheers Chippygeof for the reply.
I will have a look at the brushes when I find out where they are on the machine. Lol
My machine is 14 months old so if it is the brushes I will be sending it back to SIP.
Cheers
For the past couple of days my scrollsaw has been cutting slowly at top speed. When I turn the variable speed knob to anything below the top speed the blade stops moving.
Anybody any ideas what could be causing the machine to stop cutting at lower speeds. It is a SIP 16" if that helps.