bertterbo
Established Member
So imagine taking the mitre gauge out of the slot, flipping it 180 degrees, and putting it back in the slot.
Such that instead of the fence of the gauge being behind the cut, it's in front of the cut.
Assuming the piece being cut is clamped to the fence, is there any safety concerns with doing this?
I appreciate you won't get as clean a cut as the fibres are not supported, but I'm ignoring that for now.
In essence, it would be like using a panel sled.
Such that instead of the fence of the gauge being behind the cut, it's in front of the cut.
Assuming the piece being cut is clamped to the fence, is there any safety concerns with doing this?
I appreciate you won't get as clean a cut as the fibres are not supported, but I'm ignoring that for now.
In essence, it would be like using a panel sled.