TREND T11 Router service

[heabow]

I have a Trend T11 router with a frozen 1/2" bit that will not come out the collet is loose but the bit is well and truly stuck. I have tried soaking it in WD40 and apply some brute strength but no luck.


What can I do? or where can I take it and get it fixed. I'm in Somerset.

 

[Charlie Woody]

I had a problem with my Elu MOF96E and I took it to these guys: http://www.exetertoolshop.com/PBCPPlayer.asp?ID=1024999

They are in Exeter so not sure if that is too far for you but if it is maybe they could suggest somebody in your area.

 

[andersonec]

WD is not a lubricant or releasing agent, it's a Water Dispersant, you could try a rust releasing agent and let it soak it overnight.

Does the collet come off the router? if so use the blunt end of an old drill bit as a ream and tap it out from the back using the drill and light hammer taps.

Andy

 

[Myfordman]

Loosen, or preferably remove, the nut. Lay the router on its side on the bench with a block of wood protruding from the vice just at the right height to support the end of the shaft.
With a small hammer tap the end of the cutter downwards with small smart blows. Not necessarily hard, but short and sharp. The cutter should begin to work out of the collet.