I have been looking at the cheaper range of excaliber table saws. http://woodfordwm.co.uk/acatalog/Table_Saws1.html
There are 2 that look suitable, a tilt table and a tilt abror. Is there any advantage to the tilt table which is a bit cheaper?
On my last table saw, I would say that everything was cut at 90 degrees, with the exception of mitre joints. I now have a RAS that will do these. I dont really need the sliding carriage, useful as it was on my kity.
There are 2 that look suitable, a tilt table and a tilt abror. Is there any advantage to the tilt table which is a bit cheaper?
On my last table saw, I would say that everything was cut at 90 degrees, with the exception of mitre joints. I now have a RAS that will do these. I dont really need the sliding carriage, useful as it was on my kity.
