My dear old startrite (running on single phase 240v) is starting to play up - it will run fine for 4 or 5 minutes & then stops. It will nor re-start unless I wait a few minutes.
I have heard it may be the danfoss overload switch, and after re-wiring the main connections this does make one hell of a buzzing noise whilst the motor is running! Before I only heard the buzz on startup.... It also hums very slightly when the machine is not running but connected to the mains.
I'm thinking about gambling & stumping up the £50 for a new switch but was wondering if there are any members who have had any experience with these units or could offer advice before I part with my hard earned wedge.
Thanks in advance
I have heard it may be the danfoss overload switch, and after re-wiring the main connections this does make one hell of a buzzing noise whilst the motor is running! Before I only heard the buzz on startup.... It also hums very slightly when the machine is not running but connected to the mains.
I'm thinking about gambling & stumping up the £50 for a new switch but was wondering if there are any members who have had any experience with these units or could offer advice before I part with my hard earned wedge.
Thanks in advance