Router table insert drawings

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Thanks Tony, very good of you to have gone to the trouble to redraw

Signal
 
Roger Sinden":16g1nahf said:
Tony

Is the insert also made from Aluminium? 3mm thick?

Did you make a range with different centre holes for varying cutter diameters?

Roger

Hi Roger

Not sure if I understand you correctly. The main plate is 6mm aluminium sheet whilst the insert plates are 3mm sheet.
I made 6 insert plates with varying hole sizes to accommodate varying diameter cutters
 
What holds the inserts in?

Is there not a chance, or liklehood, of them coming out due to vibration?
Not a pretty thought if that does happen and one hits the spinning router bit
 

Latest posts

Back
Top