seanybaby
Established Member
I want to make some pepper mills and pretty much know the process. Well i've done 2 so far, first one i did the mechanism wasn't very good, second one was from axminster. From what i remember it ground very well, however i had a little trouble drilling the to take the mechanism. This was due down to the selection of saw tooth / forstner bits i have.
So my question really is what sized bits do i need to order when i buy the mechanisms? I used 25mm for the long center part, its the plastic part I'm worried about. 28mm? 30mm? :?
I would buy a whole set but can't afford at the moment.
So my question really is what sized bits do i need to order when i buy the mechanisms? I used 25mm for the long center part, its the plastic part I'm worried about. 28mm? 30mm? :?
I would buy a whole set but can't afford at the moment.