Old Ferm FZT 250 spares

[Andybos0]

Hi Folks,

Just wondering if anyone has had any luck sourcing parts for the ferm fzt 250 table saw, mine that I have had for years has finally broken and I am reluctant to dispatch the old saw to the tip as it has served me well over the years, however I am finding it hard to source a new motor.

Could anyone please help me and point me in the right direction of a supplier or an alternative, I know there will be other motors available but I am not sure which one will fit due to the limited space and the bracket for the tilt mechanism.

Regards

Andy

 

[blackrodd]

No spare's that I could find, apart from a set of brushes, link below.
The slight possibility of finding a "clone" that shared the same motor and made/sold at the same time, but still available, would be you're only hope.
I've also posted a link for a user manual, just in case its helpful, I see it was made by Ferm Omega.
Regards Rodders

http://www.solenttools.co.uk/ferm-carbo ... 89859-.php

http://doc.ferm.com/Servotool/documents ... -13%20.pdf

 

[Knot Competent]

I've got an old, working one which you're welcome to, but it's rather a long way to collect!

 

[Andybos0]

I've got an old, working one which you're welcome to, but it's rather a long way to collect!

Hi John
Thanks for the offer but yes you are right it is a long way for me to collect I am afraid to say.

once again thank you for the kind offer but by the time I had spent out the cost of fuel to collect it I could nearly buy a new ferm saw, I have looked at the new ones for about 120 quid so may go down this route.

My saw has worked well over the years and I was just hoping I could of bought a new motor which would have being ideal.

Regards

Andy

 

[JohnJ6262]

Hi Andy...or anyone still reading this thread please,

An even slimmer chance after so long but I am also after a spare part for my same table saw.

Do you or anyone have the angle guide please? The complete guide in the manual is referenced as part 407461.

Many thanks
John