AndyC Longwood
Established Member
Can anyone help, please!!!
I am struggling to fine adjust the sliding table part of my saw, at best I have achieved 1.5mm error in approximate 0.5m length of cutting despite hours of messing with the **** machine!!!
Can anyone offer any advice etc. much appriecated, before I take a big hammer to the saw!!
Regards,
Andy
I am struggling to fine adjust the sliding table part of my saw, at best I have achieved 1.5mm error in approximate 0.5m length of cutting despite hours of messing with the **** machine!!!
Can anyone offer any advice etc. much appriecated, before I take a big hammer to the saw!!
Regards,
Andy