mpooley
Established Member
I have a Jet 54A planer on which I am currently trying to use the Dakota knife setting jigs.
I found that i needed to lower the infeed table further than normal so went to my manual to have a look at what all the little gizmo's on the back were.
well :shock:
what an absolute load of rubbish the manual is!
I dont know why i never noticed before
Basicaly it shows you how to use the machine - a little bit of assemby but not much and absolutely nothing about the beds etc.
anyway I am just asking if there is somewhere ont internet or whatever where i can get the info i need
(I Have sorted lowering the bed) but i would like to know more about the machine as i feel it needs a bit of maintenance after running thousands of feet of oak over it.
any advice appreciated
Mike
I found that i needed to lower the infeed table further than normal so went to my manual to have a look at what all the little gizmo's on the back were.
well :shock:
what an absolute load of rubbish the manual is!
I dont know why i never noticed before
Basicaly it shows you how to use the machine - a little bit of assemby but not much and absolutely nothing about the beds etc.
anyway I am just asking if there is somewhere ont internet or whatever where i can get the info i need
(I Have sorted lowering the bed) but i would like to know more about the machine as i feel it needs a bit of maintenance after running thousands of feet of oak over it.
any advice appreciated
Mike