Hi All
I bought my first table saw a jet JTS -600 and have a question.
I was setting the sliding table square to the blade when I noticed that if I just check the front of the blade by touching an engineers square against a tooth that as I turn the blade I go from areas of the circumference where the teeth do not touch the square to areas where the teeth do touch.
Is this normal which is why you just pick a single tooth for set-up?
has anyone else got this saw model as I have loads of more set-up questions!!
thanks
andy
I bought my first table saw a jet JTS -600 and have a question.
I was setting the sliding table square to the blade when I noticed that if I just check the front of the blade by touching an engineers square against a tooth that as I turn the blade I go from areas of the circumference where the teeth do not touch the square to areas where the teeth do touch.
Is this normal which is why you just pick a single tooth for set-up?
has anyone else got this saw model as I have loads of more set-up questions!!
thanks
andy