Juanhandverk
New member
Hello,
I recentrly cleaned up a second hand Elektra Beckum Kgs 300. I am asking in this forum since there seems to be a lot of Elektra Beckum users.
The saw doesn't cut straight. When the blade is put down into the table insert groove, it is right in the middle of the groove while being close to the fence. However, when sliding the saw away from the fence towards the user, the blade progressively gets out of center to the point of touching (or cutting into) the left plastic table insert.
How can one adjust the saw to keep it in the middle of the table insert groove, when sliding the saw backwards and forwards? Has anybody experience this problem before when setting up the saw?
I would appreciate any comments.
Best,
Juan
I recentrly cleaned up a second hand Elektra Beckum Kgs 300. I am asking in this forum since there seems to be a lot of Elektra Beckum users.
The saw doesn't cut straight. When the blade is put down into the table insert groove, it is right in the middle of the groove while being close to the fence. However, when sliding the saw away from the fence towards the user, the blade progressively gets out of center to the point of touching (or cutting into) the left plastic table insert.
How can one adjust the saw to keep it in the middle of the table insert groove, when sliding the saw backwards and forwards? Has anybody experience this problem before when setting up the saw?
I would appreciate any comments.
Best,
Juan