Incra TS-LS Table Saw Fence?

paulkane1 · 13 Dec 2015

I have a Axminister Table Saw ,model,AW10BSB2,I have been trying to work out if the Incra Table Saw Fence (M-LS32-TS-WF-XL model) would suit my saw? I was wondering has by chance anyone on this forum,got a similar type Table Saw ,the determining factor,seems to be ,if, your saw is 32-331/2 inch along the saws Miter Slot,then the Incra Model No ,that I have just mentioned above ,should suit my saw,as,my Miter Slot measures 800 mm (311/2inches) along the Miter Slot.As I read all the different models there is in Incra Table Saw Setups,I'm getting unsure ,what model does suit my saw,So I'm hoping ,there is someone on this Forum,who has a Table Saw with a 800mm long Miter Slot ,and are using the Incra TS/LS Table Saw Fence,on their saw,Could they kindly tell me what Model No their Incra Setup is?I don't want to put out a lot of money for something,that does not suit my saw,then the whole hassle of sending the product back,for a refund,it will be a nightmare.

Yours Kindly Paul

Wizard9999 · 13 Dec 2015

Why don't you contact the WoodWorkersWorkshop.co.uk, they sell Incra kit and I have always found them really helpful.

Terry.

paulkane1 · 14 Dec 2015

Wizard9999":2wmxlzbp said:
Why don't you contact the WoodWorkersWorkshop.co.uk, they sell Incra kit and I have always found them really helpful.

Terry.

Thanks ,Will search them out and give them a call

bussy · 14 Dec 2015

Hi Paul
I have the the same table saw as you, with the TS LS 32 fitted. I bought it as the M-TS COMBO #1 XL, This came with a router table, which fits to the left of the table. The important bit is the XL. However as others have said call Peter Sefton to be sure.
Martyn

paulkane1 · 14 Dec 2015

bussy":3kzi7vap said:
Hi Paul
I have the the same table saw as you, with the TS LS 32 fitted. I bought it as the M-TS COMBO #1 XL, This came with a router table, which fits to the left of the table. The important bit is the XL. However as others have said call Peter Sefton to be sure.
Martyn

Thanks a lot Martyn,Did you buy your system from Woodworkerswork shop?If so,how much was it ?The only reason I'm asking ,is that I came across a German Company ,fine tools.com ,and they seem to be a lot cheaper,even allowing for delivery too Belfast? I'm a bit confused about your Router -Table being on your Left-Side!If you could get a chance Martyn,would it be possible to send me some images of your Setup ,What do you think of the Incra Setup?worth the money?My email add,is [email protected],if you can send me some images of your setup.

Yours Kindly Paul