EightBySix
Established Member
- Joined
- 8 Aug 2010
- Messages
- 25
- Reaction score
- 0
Hi there. I'm making a computer desk/bench with 18mm oak veneered MDF. Lots of how-to videos to get me started with the iron on edge banding, but the desk is L-shaped with a curve rather than a right angle and I'm not sure how to best apply it to the curved section, especially since it's concave - it will be hard to make good contact with the iron.
I read that contact adhesive is the best bet for curves - but how would that sit with the pre existing heat sensitive glue?
Any advice?
I read that contact adhesive is the best bet for curves - but how would that sit with the pre existing heat sensitive glue?
Any advice?