Having a senior moment I think, but can someone tell me what angle(s) I set on the SCMS for cutting cornice for a 90° int/ext corner with it laid on its back? A setting of 31.25° sprang to mind but I'm not sure.
thanks,
ike
thanks,
ike
ike":1g30g6nh said:Thanks Mark - very helpful.. I think the very last sectence sums it up well too,
"The best advice is to practice on some scrap before you delve into the real stuff".
cheers,,
ike
motownmartin":2oinefd5 said:ike":2oinefd5 said:Thanks Mark - very helpful.. I think the very last sectence sums it up well too,
"The best advice is to practice on some scrap before you delve into the real stuff".
cheers,,
ike
It always screws my head up Ike, tis the best way to practice on some scrap, it doesn't matter how many times someone tells me, I still don't get it until i've cut it :?
Enter your email address to join: