Curved face frame unit, advice please.

[mahomo59]

Hey folks I'm on my first curved face frame open shelved unit, veneered mdf carcass, solid oak face frame. So far... I've drawn a full size rod. It's going on the end of an existing kitchen peninsular. In brief, 600mm two door drawer unit in the middle cloaked with two open unit either side. Shaped a buckshee piece of ply from Rod, several holes to accommodate clamps. 2.5mm rips of oak straight off of saw (can thickness if needed). Here in the pictures there are 4 pieces that I've used as a practise with TBiii.
Face frame that I'm matching in to is 40mm wide by 25mm deep. Two shelves with be fixed and one strip applied to hide mdf.

Please share advise to make this job go as successful as your jobs.

 

[mahomo59]

Unsure why picture are not showing, same method as previous posts

 

[Roughcut]

I can see your photos fine.

 

[mahomo59]

Cheers. Photo bucket temporarily down for maintenance.

 

[katellwood]

2.5 lams on a radius that tight, you may have problems with springback

 

[mahomo59]

Ok great, that's the advice I'm after. It did feel tight! I may run it through the thicknesser after ripping, only have the dewalt thicknesser and got it second hand given to me but not used it yet, have brand new blades waiting to go in.

Thanks