RogerS
Established Member
Finally cleared enough space to be able to rebuild the spindle moulder that I bought. The manual for the autofeeder shows that it can be used both vertically and horizontally but I'm starting to think that they bought the wrong one.
This is as far forward as you can bring the rollers on the horizontal travel.
I don't think I'm doing anything wrong with the universal joints. There's enough forward travel but only with the fence pushed way, way back as to be unusable. It suggests that the mounting plate for the auto-feed is on the wrong corner but there are no fixing holes back right on the moulder.
Any suggestions? Am I right?
I'll give the guys at NMA a call on Monday but they may not be able to help if the auto-feed is not one of theirs. It's an SK-32FD from KUFO or Rexma
This is as far forward as you can bring the rollers on the horizontal travel.
I don't think I'm doing anything wrong with the universal joints. There's enough forward travel but only with the fence pushed way, way back as to be unusable. It suggests that the mounting plate for the auto-feed is on the wrong corner but there are no fixing holes back right on the moulder.
Any suggestions? Am I right?
I'll give the guys at NMA a call on Monday but they may not be able to help if the auto-feed is not one of theirs. It's an SK-32FD from KUFO or Rexma