Recent content by carlb40

There is Davies Timber, Johnsons Timber, Barlows boards, Great barr sawmills, Simon bateman ( expensive even before the prices went up), HM lowe, Bates timber, Avon timber, Timberworld ( Arnold laver) - currently the cheapest by far. Those are all of the ones i know stock birch ply in the midlands.

Kendal tools and machinery have this in the specs - Bag Diameter 50cm

The best magnetic holder i have used so far is the festool one. http://www.ebay.co.uk/itm/Festool-49253 ... 5aedb05655 http://www.ebay.co.uk/itm/Festool-Centr ... 25710f673e The magnet is good, however the holder itself really holds the standard 25mm screwdriver bits very well. None of the...

There are only a few angles used in the guns. All the framing guns use the same type. Pretty much the same for 15/ 16 ga nail guns 18ga and above are straight. The cordless framing nailers are interchangable between companies. So paslode nails will fit hitachi/ dewalt etc The one you have to...

You wont get it to work. The smallest blade for a 613 is 1/4" or 6mm according to the specs.

If its brushes or a motor they can be replaced. Check with your nearest repair place and get a quote. But it might be quicker and cheaper just to buy a new drill body.

If i didn't already have Porter cable air nail guns, Bostitch would be my top choice. :)

What i would do is carefully cut or router out the back of the door enough to get the panel out. Either repair or make a new panel, refit with a flat bead on the inside. :)

What is the intended use? I have a porter cable coil nailer that takes up 3.5 inches. With a coil of nails - pretty sure it was 200 nails at a time, it was extremely heavy. Personally a normal stick nailer would be easier / lighter to use.

You could try searching ebay for one, you may get lucky. ;)

I use city link and not had an issue so far. Ordered a pair of work trousers a week or so ago and they used interlink and my parcel had been opened to see what was inside. :evil:

Yep that was posted hours after many people rang up to complain only to be told there was nothing wrong with ebay uk #-o

Also if it's a newbie they need 3 posts before they can pm.

Yes upload to photobucket as normal. Then when choosing a pic, just choose one of the options i mentioned above to copy/ paste into a thread. :)

Or you could use photobucket or similar - you don't need to resize then. When uploaded to photobucket you just choose either direct or img code and paste into your thread :)