Router table
- Thread starter guineafowl21
- Start date
Help Support UKworkshop.co.uk:
guineafowl21
Established Member
If you tell me how, I’ll change it to ‘router table or spindle moulder?’ Or somesuch.
I have two books about the machine, but there’s no substitute for asking direct questions to an experienced user. And some things are missing from the books - for example, spindle cutters are numbered, like this 004 that came with the machine:
It’s been hanging on a little rack since it arrived, and I thought it was just a decorative moulding. It only recently occurred to me that if you run it down both sides of a piece you have a handrail. And if you cut it into pieces, possibly scribing the end as well, you have a drawer/door handle/knob.
This info is lacking in seller descriptions (cf router cutters) and would go nicely into an appendix of a book - cutter uses by number, with examples.
I have two books about the machine, but there’s no substitute for asking direct questions to an experienced user. And some things are missing from the books - for example, spindle cutters are numbered, like this 004 that came with the machine:
It’s been hanging on a little rack since it arrived, and I thought it was just a decorative moulding. It only recently occurred to me that if you run it down both sides of a piece you have a handrail. And if you cut it into pieces, possibly scribing the end as well, you have a drawer/door handle/knob.
This info is lacking in seller descriptions (cf router cutters) and would go nicely into an appendix of a book - cutter uses by number, with examples.
Attachments
Similar threads
