Hi folks , i am looking at buying a Sorby steb centre to go in my supernova chuck , although it is getting confusing as toolpost advertise steb centres to fit Supernova chuck ( yes i know , self explanatory) but would it fit in any other type of chuck if i decide to have a change . Please educate me , thanks Tony
Steb Centres
- Thread starter tony
- Start date
Help Support UKworkshop.co.uk:
Robbo3
Established Member
You can hold a morse taper centre in the centre of your chuck. Makes for a quick change.
Crown centres from Chronos are similar but much cheaper & the sell one specifically to be held in a chuck.
- https://www.chronos.ltd.uk/cgi-bin/ss00 ... N=Go&PR=-1
Crown centres from Chronos are similar but much cheaper & the sell one specifically to be held in a chuck.
- https://www.chronos.ltd.uk/cgi-bin/ss00 ... N=Go&PR=-1
Hi Robbo , i have just had a look & wondered if there is any advantage /disadvantage between the MT2 & the straight dead centre , thanks Tony
Robbo3
Established Member
Not really. It's whatever suits you or your lathe. Some lathes don't have a morse taper.tony":1g63pxjk said:
Forgot to say that carriage is free from Chronos.
If you intend to leave your chuck on permanently, get the straight sided one - if you want to just stick the thing in a chuck once in a while get the tapered one, assuming of course you have a taper in the headstock.
Thanks to you both for the advice, very helpful , cheers Tony
