Trigger
Established Member
Hi All,
Just assembled my new router table and tried to square the fence as per the manual. After an hour of being able to get one vertical face square with the table but not the other I gave up and took the fence apart. Checking the metal fence with a square and on the surface table of my saw it looks as though one half of the fence has not been bent the full 90 degress to the base leaving a 3 mm gap between the it and a square i.e. an angle less than 90. Has anyone had this problem with the Triton table and any advice as to how to overcome it please ?
Just assembled my new router table and tried to square the fence as per the manual. After an hour of being able to get one vertical face square with the table but not the other I gave up and took the fence apart. Checking the metal fence with a square and on the surface table of my saw it looks as though one half of the fence has not been bent the full 90 degress to the base leaving a 3 mm gap between the it and a square i.e. an angle less than 90. Has anyone had this problem with the Triton table and any advice as to how to overcome it please ?
