The difference between Trend craft and professional cutters.

[Newbie_Neil]

Courtesy of the Trend web site: -

"The craft range is aimed at the DIY user. The finishing methods are slightly different. The craft range is not final polished. The tungsten carbide is same as prof range but is thinner and is not full tip.(width of carbide narrower). the craft range has imperial sizes. the bearing guided cutters in the craft range have only one ball bearing, the bearing is located by the allen screw rather than a spigot and therefore is not so precice."

So now you know

Neil

 

[Anonymous]

They're not bad though!
Steve

 

[Newbie_Neil]

Hi Steve

I wasn't trying to imply that the craft range were bad, I'm sorry if it gave that impression.

I think in each review I have read that people say to buy the best cutters that you can afford and, for me, this was a justification of where the extra cost was going.

I hope this clears things up.

Cheers
Neil